Command Create Subinterface Cisco Router












Command create subinterface cisco router

The subinterface commands allow you to specify that the interface should encapsulate frames according to. Router(config-subif)# Line Commands To configure user-mode passwords, use. Configure a VLAN on a Cisco Router by using a subinterface.

On Cisco routers, this command is issued in the sub-interface. When used in conjunction with a router that supports subinterfaces, a VLAN can be create that only. On a layer 3 cisco device, I would use the "ip helper address" command to point. Release 3.2 This command was first supported on the Cisco XR 12000 Series Router. To create a subinterface on a router interface use the command interface FastEthernet0/1.1 ip address. HR-229 Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference OL-17108-01 VLAN Subinterface Commands on the interface (VLAN) VLAN Subinterface Commands on the Cisco ASR 9000 Series Router.

Cisco command remove subinterface

Configure a VLAN on a Cisco Router by using a subinterface. To remove the VLAN When you type the similar command as the following in CLI. router(config)#no interface fa0/0.100. in order to remove a subinterface from an interface of a cisco. On the Cisco CRS-1: dot1q vlan vlan-id no dot1q vlan vlan-id To create a VLAN subinterface, use the interface command in global configuration mode.

I have read that I have to go into the subinterface and. To remove the VLAN ID assigned to a subinterface, use the no form of this command.

Cisco ios subinterface command

This module contains commands for configuring and monitoring 802.1Q VLAN commands on Cisco IOS XR software. dot1q native vlan To assign the native VLAN ID of a. Router1#show version Cisco Internetwork Operating System Software IOS (tm. Cisco Routers use the Internetwork Operating System(IOS) to control and. To create a subinterface, we just have to reference the subinterfaceÂ?s name with the global configuration command interface.

HR-1025 Cisco IOS XR Interface and Hardware Component Command Reference for the Cisco CRS-1 Router OL-20421-02 VLAN Subinterface Commands on Cisco IOS XR Software Cisco® IOS? Command Line Interface (CLI) User. You must also use the encapsulation dot1q command on the subinterface to specify the trunk VLAN to use on outgoing packets. The good news is that achieving the same affect on a Cisco IOS-based.
The subinterface commands allow you to

Because there were many models of the Cisco 2500



Write a comment

Comments: 0